Gå til innhold

"Ctrl+v"-tråden - hva ligger på klippbordet ditt?

MountainRivera

Av MountainRivera
i OT-baren

Anbefalte innlegg

Videoannonse

Videoannonse
Annonse
GolfBag

GolfBag

Skrevet
Skrevet

By far, the most common smoke formula is the Potassium Nitrate/Sugar formula.

It produces a white-gray smoke and is both easy, inexpensive & fun to make.

The percentage of Potassium Nitrate and Sugar in this composition vary somewhat depending

on who you ask, but the 60/40 mix listed below is pretty common.

 

 

A lump of this stuff the size of your thumb produced the

smoke cloud on the right in under 2 seconds.

 

Potassium Nitrate 60 %

 

Sugar 40 %

 

 

Although the two ingredients can just be finely powdered and mixed together, in recent side-by-side tests, we found that melting the two together does in fact make a superior Smoke Bomb.

To melt the mixture together, you'll need small metal saucepan or other heat resistant container, and an electric hot plate. An electric hot plate is preferred to an open flame heat source because it's a tad safer, and easier to prevent overheating of the mixture.

The mixture must be heated SLOWLY, and over a LOW heat until it just starts to melt.

Heating it too quickly, or at too high a temperature will cause it to turn black, burn & ignite making a giant mess, not to mention a fire hazard. In any case, this should all be done outside just in case you overheat it does happen to ignite. As the mixture begins to melt, it will turn brown and look exactly like Carmel Candy (see image above)... after all, you are melting Sugar ( and no, you can't eat it ).

A step-by-step procedure is outlined below....

 

 

Procedure

 

 

Start by making a small size batch (50 grams total). Measure out 30 grams of Potassium Nitrate and 20 grams of Sugar into a small cup. For those of you who cut math class, 30 grams of Potassium Nitrate and 20 grams of Sugar is still a 60% / 40% mixture. If you make a batch larger than 50 grams, it will be very difficult to mix and heat evenly. You can always make more, so don't mix up a giant batch.

 

 

Snap a lid on the container and shake to mix the two chemicals together. Pour the mixture into a heat resistant container and set it on your hot plate.

 

 

Set the hot plate temperature to medium-high, and about every 30 seconds or so, stir the mixture well, being sure to scrape the material that may start sticking to the bottom.

 

 

 

Over the next several minutes, the mixture will begin to darken and clump. It will soon begin to look like brown sugar, and when it finally mixes smoothly and looks like peanut butter, it is done. If you mixture is turning BLACK, you're heating it a too high of a temperature.

 

 

Remove the container from the heat, and scoop out a lump of the sticky mass. You can either just plop some on the concrete, or if you're picky about the way your smoke bombs look, you can make small cardboard molds and press the gooey mass into them. Personally, we just lay it on the concrete.

 

 

Before the little blob cools, insert a small piece of Visco Safety Fuse.

 

 

Do this to the remainder of the material and allow them to cool and harden.

 

 

In about 5 minutes, the material will be cool and become rock hard ( beware that it will stick to the surface while cooling, but is easily removed with a little knock from a hammer. ) Set your Smoke Bomb away from any flammable materials, light the fuse and stand back.

 

The smoke from this mixture is essentially non-toxic, but that doesn't mean you should stand in a cloud of it and breathe it all day long.

Like any smoke from burning material, people may be allergic to it, or is my cause eye irritation in some more sensitive folks.

Lenke til kommentar
Gjest
Dette emnet er stengt for flere svar.
Gå til emneliste
×
×
  • Opprett ny...