Win 7 usb boot

[Morten A]

Hei, er det noen her som har en guide hvordan man lager en minnepenn som boot for windows 7 ? har ikke cden på premiumen, men har koden som fulgte med HP maskinen

[Gjest Slettet-t8fn5F]

1. Plug in your USB Flash Drive

2. Open a command prompt as administrator (Right click on Start > All Programs > Accessories > Command Prompt and select “Run as administrator”

3. Find the drive number of your USB Drive by typing the following into the Command Prompt window:

diskpart

list disk

The number of your USB drive will listed. You’ll need this for the next step. I’ll assume that the USB flash drive is disk 1.

4. Format the drive by typing the next instructions into the same window. Replace the number “1” with the number of your disk below.

select disk 1

clean

create partition primary

select partition 1

active

format fs=NTFS

assign

exit

When that is done you’ll have a formatted USB flash drive ready to be made bootable.

 

Step 2: Make the Drive Bootable

Next we’ll use the bootsect utility that comes on the Vista or Windows 7 disk to make the flash drive bootable. In the same command window that you were using in Step 1:

 

1. Insert your Windows Vista / 7 DVD into your drive.

2. Change directory to the DVD’s boot directory where bootsect lives:

d:

cd d:\boot

3. Use bootsect to set the USB as a bootable NTFS drive prepared for a Vista/7 image. I’m assuming that your USB flash drive has been labeled disk G:\ by the computer:

bootsect /nt60 g:

4. You can now close the command prompt window, we’re done here.

[Morten A]

eller bare bruke dette programmet http://www.msfn.org/board/topic/120444-how-to-install-windows-from-usb-winsetupfromusb-with-gui/

[Gjest Slettet-t8fn5F]

Vel du spurte etter en Guide.....

Om det ikke passet deg, så still rett spørsmål neste gang...

[Morten A]

var ikke ment noe kritisk med innlegget. googlet litt i mellomtiden.